Track Your Order | Returns | Shopping Cart | Your Account

What is live chat?
The Only Factory Authorized 90-70 Repair Center in the World
Factory Risk Assessment

« Back

GE Fanuc Series Six Programming Tools

Series Six Windows Programmer

Series Six Windows Programmer

Now get a small, Windows-based portable PLC programmer that allows you to run any DOS-based PLC programming software, including the Series Six programming software. No installation needed – just power-up and go!

Find out more...

The original programming tool for a GE Fanuc Series Six PLC was the Program Development Terminal or PDT. If you find yourself with one of these units, Qualitrol International can provide limited repair service on these units because so many parts are not available any longer. Please contact us at 1-800-784-9385 if you would like to have us look at your PDT.

Logicmaster Six software is the recommended tool to program your Series Six system. Logicmaster Six came in two versions – Parallel and Serial communication. The parallel version requires a Workstation Interface card, or WSI-card, that would reside in a full ISA slot in a personal computer. Due to the shortage of WSI-cards and computers with ISA backplanes, our recommendation is to use Logicmaster Six serial version, IC641SUG672.

Your computer running Logicmaster Six serial software will communicate to the Series Six CPU via a Communications Control Module, version 2 (CCM2); the part number varies depending on the age of your Series Six:

Brown faceplates: IC600CB516
Black faceplates: IC600CB536

You will need a computer with a serial communication port, either built-in or via a USB adaptor.

Logicmaster Six requires a DOS operating system. If you are running Windows, we have preconfigured an application to create a Virtual Hard Drive (VHD) on your computer that will run DOS and Logicmaster.

Contact our sales department to buy our VHD Logicmaster tool.

For more Technical Tips from our Engineers, visit our Qualitrol Blog.